Review CURT Manufacturing 56028 T-Connector| Categories | Farming, Agriculture |
| Product Code | B001GMX9Y0 |
| Product Rating |  |
| Price | $73.45 |
| Where To Buy | See More Details |
| Customer Review | See More Reviews |
CURT Manufacturing 56028 T-Connector is a new product in Farming Agriculture. You can get special discount for CURT Manufacturing 56028 T-Connector only in this month. But, you can get special discount up to 30% only in this weeks.
Most of the customer reviews speak that the CURT Manufacturing 56028 T-Connector are splendid luggage. Also, It Is a pretty well product for the price. It’s great for colony on a tight budget. We’ve found pros and cons on this type of product. But overall, It’s a supreme product and we are well recommend it! When you however want to know more details on this product, so read the reports of those who have already used it.
Please Click on The Image Below To See The Price, Reviews And Videos about CURT Manufacturing 56028 T-Connector
- Simple plug and play design eliminates the need for cutting or splicing
- Includes converter where needed
- 4-way flat output
- Comes with a dust cover to keep your connector clean when not in use
- Made in USA
Customer Reviews
Most helpful customer reviews
0 of 0 people found the following review helpful.
By RobsterMobster
Installed on a 2008 Avenger R/T in about 1.5 hours (the most time consuming is getting to the battery on this car). Remember this is designed to be installed outside, underneath of car. (someone mentioned that it took them hours to route the power cable underneath the carpeting and such through the car to the battery).Open the trunk and pull back the carpeting and remove the wing nuts holding the taillights in place (two on each side)and use a socket to depress the cone shaped holder in to release it.From underneath, go up behind the bumper and feed the short wires to the driver side taillight.Gently pull up on the red tab on the light socket and depress it to slide the socket off. Plug in the Curt Socket to the taillight and slide red tab down and do the same for the other Curt socket to the wire socket you just unplugged.Do the same for the passenger side and mount the converter box to the underside of the car with cable ties (provided).Jack up the driver side front of car and remove tire. Then remove the plastic plugs in the wheel well fascia. This is done by prying out the round center plug (not the washer looking thing)with a flat end screw driver and then a small open end wrench can be slid in and rocked side to side to get it the rest of the way. Once it is out, you can pry out the rest of the plastic piece with a screw driver. Then undo the two screws connecting it to the fender well (7mm socket).Remove the negative battery cable (12mm) and the positive (10mm) Hook up the black cable per the instructions and route under the car and put it all back together.Not very difficult at all and it works great!
This Page is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com
CERTAIN CONTENT THAT APPEARS ON THIS SITE COMES FROM AMAZON SERVICES LLC. THIS CONTENT IS PROVIDED "AS IS" AND IS SUBJECT TO CHANGE OR REMOVAL AT ANY TIME.
0 comments:
Post a Comment